One- Stop Mosaic Tile Solution for Super Market, Tile Wholesaler, Distributor, Stores, Contractors.

Language
MORE INFO
VR

How To Install Pool Mosaic Tiles

September 23, 2022

1. Tools you will need:

●  Wire brush                                            

●  Leveling mortar compound

●  Crack suppression film

●  Notched trowel

●  Thinset

●  Tile spacers

●  Rubber mallet

●  Sponge

●  Grout float

●  Bucket

●  Grout

●  Cloth

●  Detergent


Steps you should know:

1) Drain the pool to below the bottom line of where the pool tiles will be.

2) Use the wire brush to clean the entire space that will have tile, to remove the dirt and debris.

3) According to the package direction, apply the leveling mortar compound, on areas that are not level, and allow to dry.

4) Place the crack suppression film on entire area with a trowel, or buy the peel-n-stick sheets.

5) Try some new Bluwhale mosaic tile pattern you like, and place tiles on the table.

6) Apply a layer of thinset that is just thinner than the thickness of the tile with a notched trowel. Only apply what you can tile in 10 to 15 minutes.

7) Using the flat edge of the trowel, butter the backside of tiles with a thin layer of thinset. For applying clear tiles, just smooth the grooves in the thinset so that the grooves will not show.

8) Use a rubber mallet to place the tile and tap lightly into the space. Place the tile spacers and continue adding tiles until you have covered the area full of thinset. Then remove any thinset that has been displaced from setting the tile with a sponge.

9) Repeat in small sections until all Bluwhale tiles are set in the thinset. Allow 24 hours for the thinset to dry, then you can remove the tile spacers.

10) Mix small acounts of grout to a consistent condition, and apply the grout to the tile with a grout float. Press the grout into the gaps by moving grout over the tiles in all directions.

11) Continue until all tiles have grout.

12) Wash the tiles with a sponge and water to remove the excess grout from the tiles. Repeat until all the extra grout is gone. Change the water frequently to speed the process. Allow the grout to set for 24 hours.

13) Wash the tiles with a mixture of water and a mild detergent to remove any haze left from the grout.


Basic Information
  • Year Established
    --
  • Business Type
    --
  • Country / Region
    --
  • Main Industry
    --
  • Main Products
    --
  • Enterprise Legal Person
    --
  • Total Employees
    --
  • Annual Output Value
    --
  • Export Market
    --
  • Cooperated Customers
    --

Recommended

Send your inquiry

Chat with Us

Send your inquiry

Choose a different language
English
ภาษาไทย
Polski
Қазақ Тілі
bahasa Indonesia
Magyar
Hrvatski
فارسی
Ελληνικά
العربية
Deutsch
Español
français
italiano
日本語
한국어
Português
русский
Current language:English